hi
i have installed the trainer and another one and bought justflight pa28 arrow and configured avonics and setting. but running msfs , i still see old default pa28 gauge , no digital display at all
please help
Hello,
For the TDS GTNXi to run in VC integrated mode in the JF Pipers, you must perform the change from the radio stack to TDS GTNXi from within the virtual tablet located on the copilot's side, please cycle within the Aircraft Options section.
Good luck!
(11-21-2022, 10:16 AM)adminOwner2 Wrote: [ -> ]Hello,
For the TDS GTNXi to run in VC integrated mode in the JF Pipers, you must perform the change from the radio stack to TDS GTNXi from within the virtual tablet located on the copilot's side, please cycle within the Aircraft Options section.
Good luck!
You saved my whole day its done many many thanks
Great to hear that, please enjoy the TDS GTNXi!
Sorry for another same problem that i can not see tds gtn xi with flysinware cessna 414 . checked efb but no sellecter for gps there. i have used gtn xi with 414 but today suddenly disappeared. what should i do??
Hello William,
The FSW C414 has the TDS GTNXi as a livery, you must select the livery called GTN750Xi and the TDS GTNXi will show up.
(12-09-2022, 09:01 AM)adminOwner2 Wrote: [ -> ]Hello William,
The FSW C414 has the TDS GTNXi as a livery, you must select the livery called GTN750Xi and the TDS GTNXi will show up.
its also done i never expected that livery title may decide to bring which one... thank you very much for your help i may suggest that you put how to bring gps mode on manual or homepage in very big and red letters.
Hello,
Thank you for the advice, since this is a FSW C414 design decision/option and not TDS GTNXi, it is described in the FSW C414 manual!
Please enjoy the TDS GTNXi!